. 2020; 26(4): 599-604 | DOI: 10.5505/pajes.2019.46690 | |||
Midye kabuğu/epoksi parçacık takviyeli kompozitin mode-I kırılma tokluğunun deneysel olarak incelenmesiCemal KoçhanDokuz Eylül Üniversitesi Mühendislik Fakültesi Makina Mühendisliği BölümüBu çalışmada, atık midye kabuklarının geri dönüşümü ile vakum takviyeli reçine infüzyon kalıplama (VARIM) yöntemi kullanılarak üretilmiş midye kabuğu/epoksi parçacık takviyeli kompozit malzemenin mode-I kırılma tokluğu deneysel olarak incelenmiştir. Atık malzemenin üretime sokulması hem üretim maliyetinin düşürülmesi hem de çevresel kirliliğin önlenmesi açısından çalışmanın amacını oluşturmaktadır. Bu çalışmada uygulanan kompozit üretim yöntemi lif takviyeli kompozit üretimde kullanılıp parçacık takviyeli kompozit üretiminde daha önce uygulanmamıştır. Bu bakımdan seçilen takviye malzemesi ve üretim yöntemi çalışmanın iki yeniliğidir. An experimental investigation on mode-I fracture toughness of mussel shell/epoxy particle reinforced compositesCemal KoçhanDokuz Eylul University Engineering Faculty Mechanical Engineering DepartmentThis research covers investigation of mode-I fracture toughness of the recycled waste mussel shell particles reinforced epoxy composites. Vacuum assisted resin infusion molding (VARIM) method was applied to produce composites. The aim of the research is to use recycled waste shells to reduce production cost and to prevent environmental pollution. VARIM was applied to produce fiber reinforced composite. Therefore, as reinforcement particles mussel shell, and as particle reinforced composite production method VARIM are both two new points of the research. Cemal Koçhan. An experimental investigation on mode-I fracture toughness of mussel shell/epoxy particle reinforced composites. . 2020; 26(4): 599-604 Sorumlu Yazar: Cemal Koçhan, Türkiye |
|